In our commitment to offering our clients complete and personalised solutions, at Ingeteam we offer a 360º CRS service with all of our product range, providing you with comprehensive consultancy, direct technical support, training and maintenance services throughout the lifetime of our products.
360º CRS is a dynamic, personalised service that covers all of stages and contact points between Ingeteam and our clients. The 360º CRS programme is supported by a professional technical team whose goal is client satisfaction and continuous improvement of products and services, always hand in hand with the latest advances and technologies in each application sector.
Ingeteam has qualified technical staff based on its sites in Zamudio, Madrid, Mexico and Brazil.
Ingeteam's commitment to being at the technological forefront begins with its facilities, equipment and staff who are dedicated to designing, developing, simulating, manufacturing and testing our products.
A tangible example of this commitment is our communications laboratory completed in 2012. Here, Ingeteam's various product ranges for automating electrical grids are subjected to integrated solution tests under controlled conditions similar to in the field and with communications networks similar to the ones installed and with real configurations. The addition of this laboratory further assures the optimal functioning and integration of our systems.
Ingeteam has two RTDS (Real Time Digital Simulator) performing analytical power network simulations. Both protection and control devices and electronic gear can be connected to the simulated system in a closed circuit. Thus, the interaction among the electrical network and those devices can be analyzed in scenarios like those happening in the field.
Hazitek project whose main objective is to develop the necessary equipment to offer a fully digitalized substation automation solution prepared for a new exploitation scenario based on the use of data. Read flyer.
Development of a distributed unit protection solution for Medium and High voltage levels, using Process Bus protocol according to IEC 61869.
EU H2020 project that responds to the call for the demonstration of the integration system with storage technologies and intelligent transmission network with increasing renewable energy participation.
CDTI-funded project that began in 2018 and will end in 2021, whose objective is to investigate and develop new cyber attack prevention and detection technologies. Read flyer.
Co-financed with ERDF funds and subsidized by the Basque Government (Hazitek), the objective of this project is to design electrical substations with ecodesign criteria, which allow to obtain competitive advantages. Read flyer.
Project to apply innovation in the technologies and procedures of companies in the energy sector that are part of the consortium and provide their products with a high and demonstrable level of protection, allowing them to increase their competitiveness and position themselves. Read flyer.
Project that aims to develop solutions for advanced distribution automation that meet the needs of the market in upcoming years, including electronic equipment, but also the sensors necessary to capture electrical values from the network. Iberdrola acts as financier and the project has a duration of 3 years.
Communications Interoperability project to simulate the behavior of protection and control systems
E-House solution for 34.5 / 230 kV substation
800 MW photovoltaic complex, the largest in Europe
Retrofit to IEC 61850 of 161/69/23/11 kV substation
132 / 22 kV substation control system for photovoltaic power plant
RMU automation and monitoring
Global view of the solutions and product ranges for Smart Grids